Publicité
Les langues disponibles
Les langues disponibles
OPERATING FROM THE REMOTE CONTROL
INSERTING OR REPLACING THE BATTERIES
•
Remove the cover on the rear of the remote control;
•
Insert or replace the batteries with two new R03 "AAA" 1.5V
batteries, inserting them correctly (see the instructions in-
side the battery compartment);
•
Replace the cover.
If the remote control unit is replaced or discarded, the batteries
must be removed and disposed of in accordance with current
legislation as they are harmful to the environment.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries. Do not dispose of batteries in fire.
Batteries may explode or leak. If the remote control is not be
used for a certain length of time, remove the batteries.
USING THE REMOTE CONTROL
•
Point the remote control at the receiver A5 on the air
conditioner. The remote control must be no more than 23
ft (7 metres) away from the appliance (without obstacles
between the remote control and the receiver).
•
The remote control must be handled with care. Do not drop
it or expose it to direct sunlight or sources of heat.
max 23 ft
max 7 m
Note: The remote control can be safely stored in the
appropriate compartment A6 (see figure A page 3).
DESCRIPTION OF THE REMOTE CONTROL
D
D1
D2
D4
D7
D1. ON/STAND-BY (on/off) button
D2. REAL FEEL button
D3. MODE button
D4. Decrease button
D5. Increase button
D6. Air flow button
D7. WiFi button
D8. Swing button (flap swing)
TURNING THE APPLIANCE ON/OFF
•
•
•
Note: Never switch the appliance off by removing the plug.
Always switch it off by pushing the
minutes before removing the plug. Only in this way the appli-
ance will perform the standard checkings.
SELECTING THE OPERATING MODES
The operating modes available on the remote control correspond
to those on the appliance control panel C.
SELECTING THE TEMPERATURES
In conditioning modes press button > D5 or < D4 to select the
desired temperature.
SELECTING THE AIR FLOW
In conditioning and fan modes, press button
desired air flow.
The air flow available are:
D3
D5
D6
D8
9
Plug into the outlet.
button D1 . When turned on, the air condi-
Press the
tioner starts operating in the same mode as when it was
turned off.
Press the
button again to switch the appliance off.
Minimum air flow: when maximum silent opera-
tion is desired.
Medium air flow: when the noise level needs to
be low but with a good comfort level.
Maximum air flow: for maximum performance.
The appliance automatically chooses the air flow
based on the temperature selected and the envi-
ronmental conditions.This selection is only availa-
ble in conditioning mode.
button and waiting few
D6 to select the
Publicité
