LAVOR Pro QUICK 36E Mode D'emploi page 41

Photo 25
A) Metal retainer for front rubber blade
B) Front rubber blade
7.8 SQUEEGEE ADJUSTMENT
The two wheels at the sides of the squeegee (
Photo 26 -A ) and the central wheel ( Photo 27 -A
) are to adjust the pressure of the squeegee to the
floor.
These adjusting wheels are eccentric; unlocking the
fixing nut ( Photo 26 -B, 27 - B ) it is possible to ro-
tate the wheel up or down, in order to change the
squeegee pressure on the floor.
When the squeegee is perfectly adjusted, the rear
squeegee blade, sliding as it moves, bends in all
points forming an angle of 45° with the floor.
Changing properly the wheels position it is possible
to adjust the squeegee pressure; the squeegee dry-
ing must be uniform along the entire drying line;
damp patches mean that drying is insufficient; ro-
tate the adjusting wheels to optimize drying.
7 - OPERATING INFORMATIONS
A
B
A
Photo 26
A) Eccentric wheel for squeegee pressure adju-
stment - side wheel
B) Fixing nut of the eccentric wheel
B
A
Photo 27
A) Eccentric wheel for squeegee pressure adju-
stment - central wheel
B) Fixing nut of the eccentric wheel
41
B