LAVOR Pro QUICK 36E Mode D'emploi page 40

7.5 SQUEEGEE ASSEMBLY
Put the two fixing pins of the squeegee ( Photo 23
- A ) inside the holes in the squeegee support (
Photo 22 - A ).
Screw the two knobs ( Photo 22 - B ) in order to se-
cure the squeegee to the support ( Photo 22 - A ).
Connect the suction hose coming from the ma-
chine to the suction coupling pipe on the squeegee
body ( Photo 23 - B ).
7.6 SQUEEGEE DISASSEMBLY
Disconnect the suction hose from the coupling pipe
on the squeegee body ( Photo 23 - B ).
Unscrew the two knobs ( Photo 22 - B ) that secure
the squeegee to its support and push down the
squeegee to free it.
A
Photo 23
A) Squeegee fixing pin
B) Suction hose coupling pipe
7.7 SQUEEGEE BLADES DISASSEMBLY / AS-
SEMBLY
Disassemble the squeegee from its support ( see
7.5).
Unscrew the knobs ( Photo 24 - A ) and remove
metal blade retainer ( Photo 24 - B )
Extract the fixing bolts ( Photo 24 - C ) and remove
the front metal blade retainer ( Photo 25 - A );
remove the squeegee rubber blades tearing them
from a side.
To replace the squeegee rubber blades, follow the
same procedure on the contrary starting from the
front blade;
lock the fixing bolts ( Photo 24 - C ) retaining them
in the squared seats in the squeegee body;
then, place the rear rubber blade ( Photo 24 - D )
and the metal blade retainer ( Photo 24 - B ), loc-
king them with the fixing knobs ( Photo 24 - A ).
7 - OPERATING INFORMATIONS
B
A
A
Photo 22
A) Squeegee support
B) Squeegee fixing knob
A
Photo 24
A) Squeegee fixing knob
B) Metal retainer for rubber blades
C) Fixing bolts
D) Rear rubber blade
40
B
C
D
B