Lux Tools A-RM-2x20/4/33 Notice Originale page 38

Rasenmaeher_Akku_196073.book Seite 38 Donnerstag, 5. Dezember 2019 1:46 13
GB
Assembly
Mounting the handle
Note: All mounting steps must be
performed on both sides.
► P. 4, item 3
– Release the clamping lever (15).
– Fold the bottom part of the handle bar (3)
over as shown.
– Observe the installation direction:
Lugs (16) must engage as shown.
– Press the clamping lever towards the han-
dlebar.
– If the clamping lever does not safely
clamp: open the clamping lever again in a
clockwise direction and tighten it to the
limit stop.
– If the clamping lever cannot be tightened
to the limit stop: open the clamping lever,
make a counter-clockwise revolution, and
tighten it to the limit stop.
► P. 5, item 4
– Screw the handle (2) using the carriage
bolts (17) and tensioning lever nuts (18)
onto the handle under section.
– Press the clamping lever towards the han-
dlebar.
– If the clamping lever does not safely
clamp: open the clamping lever again in a
clockwise direction and tighten it to the
limit stop.
– If the clamping lever cannot be tightened
to the limit stop: open the clamping lever,
make a counter-clockwise revolution, and
tighten it to the limit stop.
Mounting the collection box
► P. 5, item 5
– Attach the collection bag (19) to the col-
lection basket upper (20).
– Press the rubber lip as far as possible into
the guide!
Using for the first time
Charging the battery pack
WARNING! Risk of injury! Comply
with all safety instructions when han-
dling rechargeable devices.
NOTICE! Risk of damage to the
unit! Do not allow the battery pack to
deep discharge.
38
Note: The Li-Ion battery pack can be
charged at any time without affecting
the lifetime of the unit. Interrupting the
charging process will not damage the
battery pack.
• The battery pack must be charged prior to
the first start-up (charging time: ► Techni-
cal data – p. 40).
– Press in the locking button (12) and
remove the battery from the device.
– Insert the battery pack into the charger.
– Plug the charger into the power supply.
The charging status is displayed by the con-
trol lights (13).
– Slot the battery pack into the device and
make sure it clicks into place correctly.
Checking the remaining capacity of the
battery
– Press the button (11).
The remaining capacity of the battery is dis-
played by the control lights (10).
Preparation
Set the cutting height
The cutting height can be set to several differ-
ent heights (Cutting heights: ► Technical
data – p. 40).
► P. 6, item 8
– Pull the lever (5) to the side.
– Set the cutting height to the value you
require, and let the lever slot back into
place.
Attach the collection box
► P. 6, item 9
– Lift the protective flap (7) and hold.
– Hook in the collection box (4).
– Make that the collection box is securely
engaged.
Operation
Check before starting!
DANGER! Risk of injury! The prod-
uct must only be put into operation if
no defects are found. Ensure that any
defective parts are replaced before
the product is used again.
Check the safe condition of the product:
– Check whether there are any visible
defects.
– Check whether all parts of the product are
firmly attached.