If you're going on vacation
If your appliance is not to be used for several months, remove all food, turn off and unplug the
appliance from the outlet. Clean and dry the inside and outside of the appliance thoroughly. Also
leave the door open, blocking it if necessary, to prevent condensation, odors, mold.
Moving the unit
After any movement, it must not be connected for 4 hours. This delay allows the coolant to
be adjusted.
Energy saving tips
• The refrigerator should be located in the coolest area of the room, away from heat
producing appliances or heating ducts, and out of the direct sunlight.
• Let hot foods cool to room temperature before placing in the refrigerator.
Overloading the refrigerator forces the compressor to run longer. Foods that freeze
too slowly may lose quality, or spoil.
• Be sure to wrap foods properly, and wipe containers dry before placing them in the
refrigerator. This cuts down on frost build-up inside the refrigerator.
• Refrigerator storage bin should not be lined with aluminum foil, wax paper, or paper
toweling. Liners interfere with cold air circulation, making the refrigerator less
efficient.
•
Organize and label food to reduce door openings and extended searches. Remove
as many items as needed at one
Changing the light bulb
This appliance consists of light-emitting diodes (LEDs). This type of
diode can be changed by the consumer. The lifetime of these LEDs
is normally sufficient for no change to be made. If however, and
despite all the care taken during the manufacture of your appliance,
the LEDs were defective, you can replace the LED yourself.
Door reversal instructions
Your refrigerator is built with a reversible door. You have the choice of either opening it from
the left or the right side. In order to reverse the opening direction of your door, please follow
these simple instructions.
1. Dismantle the upper hinge cover, screws and upper hinge. Remove the plastic screw
hole cap from the other side.
time, and close the door as soon as possible.
30