Inventum AKP6000ZWA Mode D'emploi page 18

• Always follow the installation instructions in the installation manual
(chapter 7) provided.
• Check the appliance for transport damage. Do not connect a
damaged appliance.
• Faulty parts may only be replaced by original parts. The manufacturer
can only guarantee that original parts meet safety requirements.
• If the connecting cable is damaged, it may only be replaced by the
manufacturer, the manufacturer's service organisation or equivalently
qualified persons, in order to avoid dangerous situations.
• Always use the original cable and plug to connect the appliance.
• The electrical connection must comply with national and local
regulations.
• The wall plug socket and plug should always be accessible.
• If you want to make a fixed connection, make sure that an omnipolar
switch with a contact separation of at least 3 mm is fitted in the supply
cable.
• The appliance should not be connected to the mains via a multi-plug
adapter or extension cable, as the safe use of the equipment cannot
be guaranteed.
• Warning: Never open the appliance casing. The casing may only
be opened by a service technician.
• Disconnect the appliance from the mains supply before starting any
repair work.
• We advise to wear protective gloves when assembling the cooker
hood because of the possible sharp edges.
• The distance between the lowest point of the cooker hood and the
supported surface for the cooking pans gas hob should be at least 75
cm. With an electric, ceramic or induction hob this distance should at
least be 65 cm.
• If the instructions of the gas hob specify a greater distance, this should
be taken into account.
• Warning: failure to install screws or fixing devices in accordance
with these instructions may result in electrical hazard.
• If the safety instructions and warnings are not followed, the
manufacturer cannot be held responsible for any resulting
damage.
• This appliance is intended to be used in household and similar
applications such as:
18
• English