JUNO JCU15820S5 Notice D'utilisation page 11

Problem
Water flows on the floor.
The temperature in the appli-
ance is too low/too high.
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.
Replacing the lamp
CAUTION! Disconnect the plug
from the mains socket.
1. Pull the left side of the lamp cover with
your fingers to unlock it. Remove the
cover by pulling it towards yourself.
Possible cause
The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
There is no cold air circula-
tion in the appliance.
2. Replace the lamp with one of the same
power and shape, specifically designed
for household appliances. The
maximum power is shown on the light
bulb cover.
3. Install the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door.
Make sure that the light switches on.
Solution
Attach the melting water outlet
to the evaporative tray.
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products tempera-
ture decrease to room temper-
ature before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessa-
ry.
Make sure that there is cold air
circulation in the appliance.
1
2
1
11