Whirlpool W11173681 Instructions D'installation page 9

Install Deflector Kit Bracket
This assembly is required for use when a single or double
built-in oven is installed in a flush installation.
1. Flex the upper vent piece (C) away from the lower vent
piece (D) to slide the deflector bracket (B) between them.
Some force may be required to flex the upper vent trim (C)
away from the lower vent trim (D). Some force may also
be required to flex the deflector bracket (B) and slide it
into position. Make sure screw holes are properly aligned
between the two pieces. See the following illustration.
2. Install the deflector bracket (B) to the lower vent piece (D)
using two #8-18 x / " screws on each side.
1
4
NOTE: On 27" (68.6 cm) models, only one #8-18 x
screw is used on each side.
A
A. #8–18 x / " screws C. Upper vent piece (supplied with oven)
1
4
B. Deflector bracket D. Lower vent piece (supplied with oven)
3. Align vent tab (B) with oven frame (A) as shown in the
following illustration.
4. Using one #8-18 x / " screw (E) on each side of the vent
3
8
tab (B), fasten the vent securely to the oven.
E
D
A. Oven frame
B. Vent tab
C. Oven vent
/ "
1
4
B
D
B
C
D
A
B
C
D. Deflector bracket
E. #8–18 x / " screw
3
8
5. Replace the oven racks.
6. Replace the oven door. See the "Replace Oven Door(s)"
section.
7. Check that the door is free to open and close. If it is not,
repeat the removal and installation procedures. See the
"Prepare Built-In Oven" section.
8. Repeat for lower oven door.
9. Reconnect power.
10. The display panel will light.
11. If the display panel does not light, refer to the "Assistance
or Service" section of the Use and Care Guide provided
with your built-in oven or contact the dealer from whom
you purchased your oven.
Complete Installation
1. Check that all parts are now installed. If there is an extra
part, go back through the steps to see which step was
skipped.
C
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. For oven use and cleaning, read the Use and Care Guide.
Check Operation of Single and Double Ovens
1. At first use, set up the language, clock, and any other
preferences if available. For more information, read the Use
and Care Guide.
2. Press OVEN on single oven models.
NOTE: Press UPPER or LOWER on double oven models.
3. Select Cooking Methods.
4. Select Broil.
5. Set the temperature.
6. Select Start.
If oven(s) does not operate, check the following:
Household fuse is intact and tight, or circuit breaker
■
has not tripped.
Electrical supply is connected.
■
See the "Troubleshooting" section in the Use and
■
Care Guide.
7. When oven has been on for 5 minutes, feel for heat.
If you do not feel heat or if an error message appears in the
display, turn off the oven and contact a qualified technician.
8. Press UPPER or LOWER on double ovens, or press OVEN
on single ovens, to cancel.
If you need Assistance or Service:
Please reference the "Warranty" section of the Use and Care
Guide.
9