Whirlpool W11173681 Instructions D'installation page 6

Replace Oven Door(s)
1. Using two hands, grasp side edges of door at the midpoint.
Face the oven cavity.
2. Locate the slots on each side of the oven cavity for the door
hinge locks.
A. Slot in the oven cavity for door hinge lock
3. At a 45° angle, align door hinges with slots in the lower
front of the oven cavity. Slowly insert door, making sure you
maintain the 45° angle. You will know the door is engaged
in the slot when you feel a slight drop.
4. Lower the oven door to the fully open position. If the oven
door does not open to a full 90 degrees, repeat steps 1
through 3.
5. Locate the oven door hinge locks in the corners of the oven
door, and rotate the hinge locks toward the oven cavity to
the locked position.
See Step 3 (illustration A) in the "Remove Oven Door(s)"
section for proper locked position.
6
6. Close the oven door.
7. When the hinges are properly installed and the door closed,
there should be an even gap between the door and the
control panel. If one side of the oven door is hanging lower
than the other, the hinge on that side is not properly installed.
Repeat the steps to remove, then replace the oven door. See
the "Remove Oven Door(s)" and "Replace Oven Door(s)."
sections.
Single Ovens
The positioning of the oven feet allows a single oven to be
installed in a recommended cutout height of 28
Go to the "Make Electrical Connection" section in the Installation
Instructions provided with your built-in oven.
Double Ovens
A
The oven feet need to be installed to allow a double oven to be
installed in a recommended cutout height of 51
NOTE: Do not remove the spacers.
Positioning Oven Feet
A. Spacers
1 / " (72.4 cm).
2
/ " (130.6 cm).
7
16
A
A