Sharp Plasmacluster IG-A20U Mode D'emploi page 13

UNIT (Electrode section)
Remove the rubber cover and unscrew the center screw of the Ion Generator
1
Cover. Push both corners of Ion Generator Cover and open it.
(IG-A40U only) (See page E-13)
Lift the lever to unlock it. Pull the lever forward and take out the Plasmacluster
Ion Generating Unit without removing the connector.
2 Remove the dust from the electrode section of the unit with a cotton swab.
• Use caution when cleaning electrodes as their
positions are fi xed.
• Cleaning the unit without removing connector.
• Clean with all electrode sections of the unit.
Number of the unit
<For Stubborn Dirt>
Please damp the tip of a cotton swab with little water.
When the clean the electrode section of the unit ends, replace the unit in a
3
reverse procedure.
Close the cluster door and tighten the screw of the central part. Install the
4
screw cover and insert the attaching plug in the outlet.
• Do not drive unless the cluster door completely closes. Push the both ends of the cluster
door and close surely.
Confi rm whether to drive correctly.
5
• UNIT REPLACEMENT Light (red) and
HIGH/MED./LOW Lights (blue) are
fl ashing.
fl ashing (red)
The amount of generation of the ion is
insuffi cient. Clean the electrode section of
the unit again.
IG-A20U̲A40U.eng.indd 13 IG-A20U̲A40U.eng.indd 13
Every 6 months or more often if necessary.
IG-A20U: 2
IG-A40U: 4
(IG-A40U only)
fl ashing (blue)
E-11
(See page E-14 , )
Board
Connector
Unit
1 unit x 8 places of
electrode sections
• HIGH/MED./LOW Lights (blue) are
fl ashing.
fl ashing (blue)
The connector of the unit is a bad
connection. Insert the connector surely
again.
2010/09/29 16:02:14 2010/09/29 16:02:14