EINHELL TC-PG 10/E5 Instructions D'origine page 21

10. Troubleshooting
Fault
Engine does not
start
Generator has too
little or no
voltage
Anl_TC_PG_10-E5_SPK9.indb 21 Anl_TC_PG_10-E5_SPK9.indb 21
GB
Possible cause
Automatic oil cut-out has not
responded
No fuel
Controller or capacitor defective
Overcurrent circuit-breaker has
triggered
Air fi lter dirty
- 21 -
Remedy
Check the oil level, top up with engine
oil
Refuel
Contact your dealer
Actuate the circuit-breaker and
reduce the consumers
Clean or replace the fi lter
07.11.2019 10:00:22 07.11.2019 10:00:22