Electrolux SB318N Notice D'utilisation page 55

Problem
A square symbol is shown
instead of numbers on the
Temperature Display.
The lamp does not work.
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the FROSTMAT-
IC, or after changing the
temperature.
The compressor does not
start immediately after
pressing the COOLMATIC,
or after changing the tem-
perature.
Water flows inside the re-
frigerator.
Possible cause
The temperature in the ap-
pliance is too high.
Temperature sensor prob-
lem.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The FROSTMATIC func-
tion is switched on.
The COOLMATIC function
is switched on.
This is normal, no error
has occurred.
This is normal, no error
has occurred.
The water outlet is clog-
ged.
Food products prevent
that water flows into the
water collector.
ENGLISH
Solution
Refer to "Door Open Alarm"or
"High Temperature Alarm".
Contact the nearest Author-
ised Service Centre (the cool-
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible).
Close and open the door.
Contact the nearest Author-
ised Service Centre.
Refer to "Operation" chapter.
Wait some hours and then
check the temperature again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "FROSTMATIC func-
tion".
Refer to "COOLMATIC func-
tion".
The compressor starts after a
period of time.
The compressor starts after a
period of time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
55