Mitsubishi Electric Mr.SLIM PLA-MEA Serie Manuel D'installation page 22

9. Installing the grille
A
en
20
D
C
B
G
F
Fig. 9-12
9.5. Installing the intake grille (Fig. 9-12)
Note:
When reinstalling the corner panels (each with a safety strap attached), con-
nect the other end of each safety strap to the grille as shown in the illustration.
* If the corner panels are not attached surely, they may fall off while the main unit is
operating.
H
• Perform the procedure that is described in "9.2. Preparing to attach the grille" in
reverse order to install the intake grille and the corner panel.
• The direction of the intake grille can be changed according to the wishes of the
customer.
A Screw (4 × 16)
B Corner panel
E
C Safety strap
D Hook
E Refrigerant pipe
F Drain pipe
G Company logo
* Installation in any position is possible.
H Initial position of the levers on the intake grille
* Although the clips can be installed in any of 4 positions, the configuration shown
here is recommended. (It is not necessary to remove the intake grille when main-
tenance is performed on the electrical box of the main unit.)