Bartscher A150.513 Mode D'emploi page 19

5. Installation and operation
5.1 Safety instructions
WARNING! Electrical hazard!
The device must only be connected to a properly installed single socket with
protective contact.
Never yank cord to disconnect from outlet. Cable must not touch any hot parts.
•
See that the cable does not touch any heat sources or sharp edges. Do not let the
cable dangle over the counter edge.
WARNING! Danger of burn!
During operation some parts of the device become very hot. In order to avoid
injuries do not touch any hot parts.
•
Do not use the device in case it does not function properly, has been damaged or
dropped.
•
Do not use any accessory or spare parts that have not been recommended by the
manufacturer. These can be dangerous for the user or lead to damages of the device
or personal injury, and further, the warranty expires.
•
Do not lay the cable over carpets or heat insulations. Do not cover the cable. Keep
away the cable from operating range and do not dunk it into water.
•
Do not move or tilt the device when in operation.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with that
of the device (see type label).
Connect the device only in case of compliance! Take note of the security advice!
5.2 Installation and connection
Place the device on top of an even and safe surface which supports the weight of the
o
device and is not heat sensitive.
Not at any time should you place the device on an inflammable surface (such as:
o
table cloth, carpet, etc.).
You must not position the device near open fireplaces, electric ovens/arc furnaces,
o
furnaces/electric heaters or other heat sources.
The electrical circuit in the socket must be secured to at least 16A. Only connect the
o
unit directly to the wall socket; do not use any extension cords or power strips.
Position the device in a way so that the power plug is always accessible.
o
- 19 -