KWC AQRM553C Notice De Montage Et De Mise En Service page 5

5. Scope of delivery
6. Dimensions
7. Installation example
8. Basic installation kit assembly
8.1 Mount the flush-mounted casing.
8.2 Install the plastic hoses in the protective tube of the flush-mounted casing for the
WC flusher.
A: minimum bend radius 100 mm
B: to WC flusher
C: wall surface
8.3 Screw on the access eye cover before tiling. The front edge of the casing should be
flush with the tiled wall.
9. Pre-fabricated kit assembly
9.1 Flush the pipes in accordance with DIN 1988.
9.2 Tighten the union nut.
D: flushing pipe
9.3 Open the water supply.
9.4 Push in the plastic hoses in the thrust collars until resistance is met (green –green;
white – white).
E: protective pipe
F: internal flushing pipe Ø 26cm
9.5 Remove the access eye cover.
9.6 Push in the plastic hoses in the thrust collars until resistance is met (green –green;
white – white).
9.7 Install the cover plate on the flush-mounted casing complete with auxiliary valve.
- 5 -