Toro 20956 Mode D'emploi page 9

Figure 8
1. Dipstick
2. Add marker
3. Carefully pour about 3/4 of the engine capacity
of oil into the oil-fill tube.
4. Wait 3 minutes for the oil to settle in the engine.
5. Wipe the dipstick clean with a clean cloth.
6. Insert the dipstick into the oil-fill tube, then
remove the dipstick.
7. Read the oil level on the dipstick
•
If the oil level on the dipstick is too low,
carefully pour a small amount of oil into the
oil-fill tube, wait 3 minutes, and repeat steps
5 through 7 until the oil on the dipstick is at
the correct level.
•
If the oil level on the dipstick is too high, drain
the excess oil until the oil on the dipstick is
at the correct level; refer to
Engine Oil (page
Important:
If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
8. Install the dipstick into the oil-fill tube securely.
All manuals and user guides at all-guides.com
3. Full marker
(Figure 8).
Changing the
21).
4
Charging the Battery
No Parts Required
Procedure
Electric-Start Model Only
Refer to Charging the Battery (page
g033377
5
Assembling the Grass Bag
No Parts Required
Procedure
1. Slip the grass bag over the frame as shown in
Figure 9.
1. Handle
2. Frame
Note:
Do not slip the bag over the handle
(Figure 9).
8
22).
Figure 9
3. Grass bag
g027257