Toro 20956 Mode D'emploi page 24

Replacing the Fuse
For Electric-Start Models
If the battery does not charge or the engine does not
run with the electric starter, the fuse may be blown.
Replace it with a 40 A plug-in type fuse.
1. Raise the rear deflector and locate the battery
compartment (Figure
Figure 36
1. Rear deflector
2. Screw
2. Wipe away any debris from the battery
compartment area.
3. Remove the screw that secures the battery
compartment, pull out the battery, and locate the
fuse (Figure 37).
Figure 37
1. Cover
2. Fuse holder
All manuals and user guides at all-guides.com
36).
g009506
3. Battery
4. Battery compartment
g017398
3. Fuse
4. Replace the fuse in the fuse holder
Note:
Your machine comes with a spare fuse in
the battery compartment.
5. Install the battery compartment with the screw
that you removed in step 3.
6. Install the cover over the battery compartment.
7. Lower the rear deflector.
Lubricating the Wheel
Gears
Service Interval: Every 25 hours
1. Wipe the grease fittings just inside the rear
wheels with a clean rag
1. Grease fitting
2. Install a grease gun onto each fitting and gently
apply 2 or 3 pumps of No. 2 lithium grease.
23
(Figure
(Figure 38).
Figure 38
37).
g003234