Novonova SY-1025 Manuel D'instruction page 29

TREADMILL COMMON ERROR MESSAGES PROMPT DESCRIPTION
E01: communication blocked between Electronic and controller.
Solution
E02: The controller does not detect the voltage of the motor line.
Solution
E03: When the motor is running, the controller can't test the speed
signal.
Solution
E05: When the motor is running, current exceeds the rated current.
Solution
E07: Monitor can't test the signal of security lock.
Solution
RUNNING BELT ADJUSTMENT METHOD
1.When running belt lean to the left, adjusting screw on the left 1-2 turns along the clockwise.
Then, test running; If still lean to the left, repeat the above steps until back to the center.
2.When running belt lean to the right, adjusting screw on the right 1-2 turns along the clock-
wise. Then, test running; If still lean to the right, repeat the above steps until back to the
center.
3.When the running belt too tight, it will cause stronger resistance. Please adjust both sides
screws 1-2 turns along the counterclockwise, loosen the belt until stopping skidding or paus-
ing; When the running belt too loose, please adjust both sides screws 1-2 turns along the
clockwise.
When communication line is blocked
between Electronic and under controller
When Electronic without signal
When under controller without signal
Motor cable is not connected
No voltage output or abnormal by under
controller
Motor is bad
Motor cable is not connected
Under controller with abnormal signal
Treadmill motor load exceeds the rated
current
Treadmill motor assembly structure
problems, causing the motor blocked or
resistance
By limiting control system failure
Safety Magnet off
Electronic Safety lock system
malfunction
Please connect again or change
Change Electronic to repair
Change under controller to repair
Change under controller to repair
Change under controller to repair
Recommend within the rated current of
Check the structure of treadmill
Change under controller to repair
Please set magnet safety lock correctly
Change electronic to repair
13
communication line
Check connection
Change motor
Check connection
the motor
EN