Novonova SY-1025 Manuel D'instruction page 19

Attention: Make sure all screws and nuts are tightened before Exercise.
Step 1: Extending the framework
1. Both men take the treadmill out of the box and lay it flat on the ground.
2. Remove the fixing screws of the straight arrow in the picture below and erect the column
and watch in the direction of the curved arrow.
Step 2. Assembly mode
1. The column is connected to the base: The left and right columns and the base holes are
assembled in the screw bag as shown in the figure below. A.M8 * 40 and B. flat pads are
respectively tightened in the tool kit M5 wrench.
2. Electronic watch and column connection: as shown in the figure below, the B.M8 * 16
EN
and C flat pads are respectively assembled into the left and right columns and electronic
watch holes and tightened with the Toolkit M5 wrench.
C
D
C
D
A
B
3