Thetford SANICON 400S Mode D'emploi page 5

Connect Electrical
Wires should be covered to protect from foreign objects
NOTICE AVISO DANGER AVIS
! ! ! ! ATTENTION ATENCIÓN CAUTION
and water
ATTENTION ATTENTION ATTENTION
Refer to Fig. 1 and Fig. 4.
Ref. Description
4A RV Power Source
4A.1 Power Source Red Wire
4B Ground Lug / Chassis Ground or negative battery terminal
K1 Pump Assembly
K1.4 Pump Black Wire
K1.5 Pump Blue Wire
K1.6 Pump Black Wire - Negative (Long Wire)
K3 Switch Box / Wiring
K3.1 Quick Connects Red Wire
K4 Fuse Holder / 35AMP Fuse
Wire Size
■ Wire size is dependent on the distance between the pump
and power source. Actual wire sizes should be calculated
according to installation. Refer to Fig. 3.
■ Excess wire can be cut to length.
1. Disconnect positive red wire to the RV battery
2. Attach the switch box
(K3)
3. Route and connect the black and blue switch box leads to
the short black (K1.4)
supplied electrical connectors. To seal heat shrink connectors,
heat the connectors after wires are connected. Connect
additional wiring if required.
4. Route the long black wire (negative)
assembly to the battery's
(K1)
to a ground lug on the RV, or to an OEM provided chassis
ground .
(4B)
5. Locate the power source (battery or other main power source)
where the electrical connection will be made.
6. Route the red wire (K3.1)
fuse holder .
(K4)
97652 Rev. C (04.05.18)
4B
+
4A
4A.1
(4A)
inside RV compartment
and blue pump (K1.5) leads using
(K1.6) from the pump
negative terminal, or
(4A)
from the switch box (K3)
K1.6
K4
BAT
AUX
K3
Fuse
Fig. 4
K3.1
7. Crimp one end of the fuse holder to the red wire
attach the other end to the red wire
NOTICE
8. Attach the other end of the red wire
source
(4A)
9. Protect all the wiring for the SANICON® system with a wire
sheath (not provided).
10. Reconnect the red (positive) wire, that was removed in step 1
of this procedure, to the RV's battery.
.
.
(5D)
to the
SANICON
5
K1.5
K1
K1.4
(4A.1)
The fuse holder should be mounted within 18 " of
(K4)
the power source.
(4A.1)
.
®
Turbo Model 400S - Permanent Bayonet Mount
(K3.1) and
.
to the power