Starting, Using, Closing The Set-Up Mode - VOLTCRAFT 4500ADVANCED Mode D'emploi

The information in the lower display can be toggled with the "
displays are available:
b) Starting, using, closing the set-up mode
• The set-up mode can be started and closed by pressing the "SET" button (1) for about
3 seconds each time. The settings are applied when closing.
Alternatively, if you do not press any button for one minute, the set-up mode is closed
automatically and the setting made so far are also applied.
• The functions are toggled by briefly pressing the "
Following functions are available:
- Time
- Electricity tariff 1 and 2 (and their starting time)
- CO emission
2
- Alarm for overloading
- Delete mode
• If the setting of the function shown in the display is to be changed, briefly press the "SET"
button (1).
Then, change the flashing value with the "
"SET" button (1) to get to the next input or to complete input (depending on the function).
36
Current time of day
Energy in kWh ("ENERGY")
Costs ("COST")
Energy in kWh ("ENERGY")
Operating time ("TIME")
CO /greenhouse gas ("GHG/CO
2
" button (5). The following
")
2
" button (5) unless a setting flashes.
" (4) or " " (5) button and press the