Publicité
ASSEMBLE FRONT WHEEL TO
MOWER (See Fig. 3)
•
Using shoulder bolt, washer and locknut from parts
bag, as sem ble front wheel to mower as shown. Tighten
securely.
INSTALL MOWER AND DRIVE BELT
(See Figs. 4-12)
See MOWER AND DRIVE BELT ASSEMBLY Supplement
Sheet for additional guidance on this assembly.
Be sure tractor is on level surface and engage park ing
brake.
•
Lower attachment lift lever to it's lowest position.
CAUTION: Lift lever is spring loaded. Have
a tight grip on lift lever, lower it slowly and
engage in lowest position.
•
Turn steering wheel to the left as far as it will go and
position mower on right side of tractor with deflector
shield to the right.
02965
•
Remove plastic tie securing belt, bring belt forward
and check belt for proper routing in all mower pulley
grooves.
ASSEMBLY
FIG. 3
FIG. 4
NOTE: Be sure mower side suspension arms (A) are point-
ing forward before sliding mower under tractor.
•
Slide mower under tractor until it is centered under
tractor.
•
FIRST INSTALL ANTI-SWAY BAR (S).
- From right side of mower, insert anti-sway bar into
hole in transmission bracket (T).
- Pivot bar towards you and insert other end of bar
into hole in rear mower bracket (D). Move mower as
needed to insert bar.
- Secure with washer and retainer spring as shown
using small 5/16 retainer spring.
D
7
A
FIG. 5
T
S
A
FIG. 6
FIG. 7
02995
02996
Publicité
