LaserLiner X1-Laser Mode D'emploi page 14

1
Use of lithium-ion rechargeable battery
– The power supply unit is to be used in enclosed
spaces only; do not expose to moisture or rain as
this may result in the risk of electric shock.
– Charge the device's battery completely
prior to use.
– Connect the power supply unit to the mains and
connecting socket on the battery pack. Only use
the power supply unit provided. Using a different
power supply unit will invalidate the warranty.
– The LED on the battery pack lights up red
while the battery is charging.
– The status indicator (7) flashes if the battery charge is low. The status indica-
tor (7) and the hand receiver mode LED (5) then both flash at the same time
until the device shuts down to protect the battery.
The battery may only be charged with the battery charger provided
!
and used only in this laser device. Any other use may cause injury
or fire.
Make sure there are no conductive objects in the vicinity of the
!
battery contacts. Short-circuiting of these contacts can cause burn
injuries or fire.
!
Do not open the rechargeable battery. This could cause short-circuits.
2
Power supply
To insert the lithium-ion
rechargeable battery
Open the battery compartment and
insert lithium-ion battery as illus-
trated (contacts first).
14
EN