QiCYCLE N2 Manuel D'utilisation page 17

Troubleshooting
Problem Solution
1. Check whether the air compressor's
battery level is sufficient.
2. Check whether the air hose is leaking.
Slow inflation speed 3. Check whether both ends of the air
hose are securely connected.
4. Check whether the item that is being
inflated is leaking.
1. Check whether the air hose is removed
from its compartment before inflating.
Air compressor turns on 2. Check whether the air compressor's
but does not inflate battery level is sufficient.
3. Check whether the pressure of the
item that is being inflated exceeds the
preset pressure.
Make sure the air compressor is set to
Unable to increase or the correct mode. It is allowed to adjust
decrease the preset the preset value in the range of 3–150 psi
pressure in manual mode.
Air compressor inflates The pressure of low-pressure inflatables
normally but the displayed including balloons is too low to measure.
pressure is zero
Air compressor already Press and hold the start/stop button to
turned off after connecting turn the air compressor on again.
the air hose to a valve
Air leaks out when Make sure the air hose is securely
connecting the air hose connected.
The lithium battery's voltage level drops
Color of the battery level when discharging power, causing the
indicator is different when battery level indicator to have a different
inflating compared to c ol o r w hen i nfl at i ng com pared to
standby state standby state. This is normal.
The indicator does not Replace the adapter with safe and
light up after charging compliant ones, and charge again.
17