NOTE: Remove andsave thewasher, screen, andscreen h older
oraerator forfuture use.
B
...........................
C
....................................
A. Washer
B. Screen
C. Screen holder or aerator
Connecting
the faucet adapter to faucets with
external threads
Insert the 2 screens and then the thin washer from the faucet
adapter kit into the faucet adapter. Attach the adapter onto the
end of the faucet.
NOTE: Do not use the thick washer.
A ......................................
C
......................................
A. Thin washer
B. Screens
C. Faucet adapter
Connecting
the faucet adapter to faucets with
internal threads
Insert the 2 screens, the thin washer, and then the thick washer
from the faucet adapter kit into the faucet adapter. Attach the
adapter onto the end of the faucet.
NOTE: Use both washers.
B .........................
@
oliiiiiii
A. Thick washer
B. Thin washer
C. Screens
D. Faucet adapter
:: ::::
1. Run water at the faucet until it is hot. Turn off the water.
2. Pull the hoses out of their storage compartment
on the back
of the dishwasher.
NOTE: Make sure the hoses are not kinked or twisted. Kinked
hoses reduce washing performance.
3. Pull down on the locking collar while lifting the hose
connector onto the faucet adapter.
4.
5.
6.
A. Faucet adapter
B. Locking collar
C. Hose connector
When the connector snaps into place, release the locking
collar.
Turn the hot water on slowly until it is all the way on.
Plug into a grounded 3 prong outlet,
You can draw water from the faucet while the dishwasher is
connected.
NOTE: Do not draw water while the dishwasher is filling or while
water is being pumped out, (This helps prevent a low fill when
dishwasher is filling or mixing drain water with fresh water when
dishwasher is draining.)
Press the red button on the hose connector to draw water from
the faucet. (The faucet is set on hot. Adjust the faucet for the
water temperature
you want.)
NOTE: Turn the hot water back on after you draw water from the
faucet. Turn off the cold water.