Kenmore ULTRA WASH 665.1784 Serie Guide D'utilisation Et D'entretien page 13

Heavy Wash
Use this cycle for loads with heavy food soil.
Use both detergent dispenser sections.
Wash Main Rinse or Final Dry Approximate Water
Wash Purge Rinse Time Usage
(gal/L)
• • • • • 2 hrs* 6.9/26.1
Purge
Normal Wash
Use this cycle for loads with normal amounts of food soil. (The
energy-usage label is based on this cycle.)
Use covered detergent dispenser section.
Wash Main Rinse or Final Dry Approximate Water
Wash Purge Rinse Time Usage
(gal/L)
• • • • 1.5 hrs* 4.6/17.4
Purge
Light Wash
Use this cycle for china and crystal. This cycle uses a light
wash and gentle dry. During the heated dry, the heating
element cycles on and off.
Use covered detergent dispenser section.
Wash Main Rinse or Final Dry Approximate Water
Wash Purge Rinse Time Usage
(gal/L)
• • • • 1.5 hrs* 4,8/18.2
Purge cycled
Quick Rinse
Use this rinse cycle for rinsing dishes, glasses, and silverware
that will not be washed right away.
Do not use detergent with this cycle.
Wash Main Rinse or Final Dry Time Water
Wash Purge Rinse (min) Usage
(gal/L)
• 10 2,2/8.3
Rinse
* If the incoming water temperature is less than the
recommended temperature, the cycle will automatically
compensate by adding time and heat as needed.
1. Press CANCEL/DRAIN. The Cancel/Drain light glows.
2. The dishwasher starts a 2-minute drain (if needed). Let the
dishwasher drain completely. The light turns off after
2 minutes. The door must be closed for the dishwasher to
drain.
To stop the drain
You can press CANCEL!DRAIN again to stop the drain.
Remember to drain the dishwasher before starting a new cycle.
i
To clear the indicators
Press CANCEL!DRAIN before starting the dishwasher to clear all
options and cycles.
During the first minute of a cycle
1. Select a new cycle and/or options.
2. Check the detergent dispensers. They must be filled properly
for the new cycle.
3. The Start/Resume light will flash when the door is opened.
Make sure the door is closed.
4. Press START/RESUME
After the first minute of a cycle
1. Press CANCEL!DRAIN. The Cancel/Drain light glows. Your
dishwasher starts a 2-minute drain (if needed). Let the
dishwasher drain completely.
2. Check the detergent dispensers. They must be filled properly
for the new cycle.
3. Make sure the door is closed.
4. Select a new cycle and/or options.
5. Press START/RESUME.
You can add an item anytime before the main wash starts. Open
the door and check the detergent dispenser. If the cover is still
closed, you can add items.
To add items
1. Carefully open the door slightly to stop the cycle. Wait for the
spraying action to stop before opening the door. The Start/
Resume light will flash.
2. Open the door. If the detergent dispenser cover is still closed,
add the item.
3. Close the door firmly until it latches.
4. Press START/RESUME
IMPORTANT: If Lock On is selected, turn off the lock (see Lock
On section in "Option Selections"), or the Start/Resume light will
continue to flash.
iiii _iiiii_;i_
13