Subaru H001SFL200 Instructions D'installation page 9

12
POST INSTALLATION CHECKLIST
1. REMOTE ENGINE START- Ensure the Access key is removed from the vehicle, the engine hood, all doors
and trunk are closed. Press the START button on the remote start transmitter two (2) times within three
(3) seconds. The vehicle's parking lights should fl ash and the vehicle's horn should honk one (1) time and
then the vehicle should crank and start. Once started, the transmitter LED will fl ash two (2) times and the
parking lights will turn on and stay on signifying the vehicle is running. The transmitter LED will fl ash one
(1) time every three (3) seconds signifying the vehicle is still running.
2. SHUT DOWN WITH DOOR OPENING - While the vehicle is running by the remote engine start, wait at least
fi ve (5) seconds and then confi rm that all functions (lock, unlock & trunk, but not panic) operate properly on
the FACTORY transmitter. Once the FACTORY transmitter functionality is confi rmed, press the UNLOCK
button on the FACTORY transmitter and open any vehicle door. The remote engine start should shut down
and the transmitter LED should fl ash three (3) times indicating the system has shut down.
3. ACTIVATION WITH DOOR OPEN - Ensure the Access key is removed from the vehicle and the engine hood
and trunk are closed. Open the driver's door and press the START button on the remote start transmitter two
(2) times within three (3) seconds. The vehicle's parking lights should fl ash and the vehicle's horn should
honk six (6) times. The vehicle should not start with any door or trunk opened.
4. BRAKE PEDAL SAFETY - While sitting in the vehicle with the engine hood, all doors and trunk closed,
activate the remote engine start and press the brake pedal. The vehicle should shut off.
5. HOOD SAFETY SWITCH - Open the engine hood and activate the remote engine start. The vehicle's parking
lights should fl ash and the vehicle's horn should honk two (2) times. The vehicle should not start since the
hood safety switch is activated.
6. HEATER / AC FUNCTION - With the Access key inside the vehicle, press the start button on the dashboard
two (2) times to turn ON the ignition. Preset the vehicle's heater or air conditioning to the ON position. Press
the start button on the dashboard one (1) time to turn OFF the ignition and remove the Access key from the
vehicle. Activate the remote engine start and verify that the heater or air conditioning turns on to the preset
setting for manual climate controlled vehicles or turns to the "Full Auto" setting for electronic climate control
vehicles.
7. 15 MINUTE RUN TIME - Activate the remote engine start and allow the system to run for the 15 minute
preset run time. The remote engine start should shut down after 15 minutes (+/- 10 seconds).
8. TRANSMITTER FUNCTIONALITY VERIFICATION - Activate the remote engine start using both of the
supplied single button remote start transmitters.
FUNCTIONAL TESTING IS NOW COMPLETE.
PART NUMBER ISSUE
H001SFL200
DATE
00 30 Nov 2016
SUBARU OF AMERICA
9 OF 9
4280703 Rev - 11/30/16