Publicité
Les langues disponibles
Les langues disponibles
10
SYSTEM POWER-UP
1. After all the connections are complete, re-connect the vehicle's negative battery terminal. Using a 10mm socket/
torque wrench, tighten the 10mm nut to 7.5 Nm +/- 2 Nm (0.76 Kgf-m +/- 0.2 Kgf-m, 5.5 ft-lbs +/- 1.5 ft-lbs).
2. Start the vehicle at least one (1) time using the Access key prior to activating the remote engine start system. This
is required to allow the vehicle's electronic systems to re-synchronize.
3. With the vehicle running via the Access key, verify that the instrument cluster airbag light turns off. If the airbag light
remains on, refer to the vehicle service information for troubleshooting.
4. Refer to the vehicle Owner's manual for the Power Window Reset Procedure to restore the power window functions.
11
SYSTEM REGISTRATION
DST-i SETUP
Plug the DST-i
diagnostic plug
into the vehicle's
diagnostic connector
REGISTRATION
Using the arrows
on the DST-i, select
Using the arrows
on the DST-i, select
"Immobilizer"
Using the arrows
on the DST-i, select
DST-i screen will
display "Successful
[Remote Engine Start
CM Registration]
Press OK"
PART NUMBER
ISSUE
H001SFL200
With an Access key
inside the vehicle,
turn ON the ignition
Using the arrows
on the DST-i, select
PRESS
A
"Name"
"Impreza"
DST-i screen will
display "Press YES if
PRESS
A
it is a smart system,
otherwise press NO.
Using the arrows
on the DST-i, select
PRESS
"Remote Engine Start
A
"YES"
CM Registration"
Using the arrows
on the DST-i, select
"OK"
DATE
00
30 Nov 2016
Press and hold the DST-i
"B" and "A" buttons
simultaneously for
approximately 5 seconds
to enter stand alone mode
Using the arrows
PRESS
on the DST-i, select
PRESS
A
"Model year"
Using the arrows
PRESS
on the DST-i, select
"YES"
DST-i screen will
display "Execute
PRESS
Remote Engine Start
A
CM Registration?
Press YES or NO
Registration
PRESS
A
Complete
SUBARU OF AMERICA
Using the arrows on the
DST-i, select Diagnostic
and Press "A" to proceed
to Registration
Using the arrows on
the DST-i, select the
A
vehicle model year
"XXMY"
PRESS
A
DST-i screen will
display "Check if
A
Ignition SW is
turned ON."
Using the arrows
on the DST-i, select
"YES"
PRESS
A
8 OF 9
Publicité
