Subaru H001SFL200 Instructions D'installation page 3

5
REMOTE ENGINE START ECU MOUNTING
1. Locate the factory immobilizer module and bracket
mounted near the upper, left side of the passenger's
side dashboard. Using alcohol, clean the left side of the
immobilizer module bracket, as shown. (FIGURE F)
2. Remove the release liner from the remote engine
start ECU and attach it to the left side of the factory
immobilizer module bracket. Ensure the bottom of the
remote engine start ECU is fl ush with the bottom of the
immobilizer module bracket, as shown. Press fi rmly in
place for at least 30 seconds. (FIGURE G)
NOTE: Ensure the remote engine start ECU
connectors will be facing toward the rear of the
vehicle.
3. Using one (1) of the supplied 39cm tie wraps, secure
the remote engine start ECU to the immobilizer module
bracket. Trim off the excess tie wrap. (FIGURE H)
PART NUMBER ISSUE
H001SFL200
DATE
00 30 Nov 2016
Clean with
Alcohol
FIGURE F
Remote Engine
Start ECU
FIGURE G
FIGURE H
SUBARU OF AMERICA
3 OF 9