Subaru H001SFL200 Instructions D'installation page 4

6
PRE-ARRANGED JUMPER HARNESS CONNECTIONS
1. Locate and release the vehicle's 8-pin and 2-pin pre-
fi t connectors secured to the vehicle's wire harness
with breakaway tape near the upper, right side of the
passenger's side dashboard. (FIGURE I)
2. When the vehicle's 8-pin and 2-pin pre-fi t connectors
are free from the breakaway tape, unplug and discard
the 2-pin mating connector/wire jumper. (This is used
for the power window interrupt circuit).
3. Plug the remote engine start pre-arranged jumper
harness 8-pin and 2-pin connectors into the
corresponding pre-fi t connectors. (FIGURE J)
4. Route and secure the pre-arranged jumper harness
to the vehicle's wire harness using three (3) of the
supplied 20cm tie wraps at the white tape rings. The
tie wrap on the left is hidden from view. Trim off the
excess tie wraps. (FIGURE K)
5. Plug the pre-arranged jumper harness 12-pin connector
into the 12-pin white port on the remote engine start
ECU, previously mounted to the left side of the factory
immobilizer module bracket (Step 5). (FIGURE K)
PART NUMBER ISSUE
H001SFL200
DATE
00
30 Nov 2016
FIGURE I
FIGURE J
FIGURE K
SUBARU OF AMERICA 4 OF 9