Publicité
Les langues disponibles
Les langues disponibles
HOOD SAFETY SWITCH MOUNTING
8
1. In the engine compartment, locate the 2-pin pre-fit hood safety switch
connector secured to the wire harness with breakaway tape along the
frame rail on the passenger's side of the vehicle (FIGURE Z).
2. Loosen slightly the rear (top mounted) 10mm bolt and remove the front
mounted 10mm bolt securing the power steering fluid reservoir tank
and move the power steering reservoir tank slightly for easier access
to the 2-pin pre-fit hood safety switch connector. (FIGURE AA)
3. Mount the hood safety switch bracket behind the power steering
reservoir tank mount making sure the mounting bolt hole on the bracket
lines up with mounting bolt hole on the power steering reservoir tank.
(FIGURE BB)
4. Reinstall the front 10mm mounting bolt and re-tighten the rear (top
mounted) 10mm mounting bolt. Torque both mounting bolts to 10.8
Nm +/- 2 Nm (1.10 Kgf-m +/- 0.2 Kgf-m, 8 ft-lbs +/- 1.5 ft-lbs).
5. Securely mount (snap-in) the supplied hood safety switch into the
bracket and plug the vehicle's pre-fit 2-pin female hood switch connector
to the base of the hood safety switch. (FIGURE BB)
UNDER HOOD WARNING LABEL MOUNTING
9
1. Using alcohol clean the top of the air intake plenum.
2. Remove the adhesive backing of the underhood warning
label and secure to the top of the air intake plenum.
(FIGURE CC)
PART NUMBER
ISSUE
H001SAJ000
DATE
01
04/29/09
SUBARU OF AMERICA
FIGURE Z
FIGURE AA
FIGURE BB
WARNING: / AVERTISSEMENT
This vehicle is equipped with a remote controlled engine starter.
To reduce the risk of serious Injury or death, switch engine starter
system into service mode and disconnect the vehicle battery
before performing any service on the vehicle.
Ce véhicule est doté d'un démarreur à distance. Pour réduire les
risques de blessures graves ou mortelles, mettre le démarreur à
distance en mode service et débrancher la batterie du véhicule
avant d'effectuer des travaux d'entretien sur celui-ci.
FIGURE CC
7 OF 10
Publicité
