BS GROUP RADIATIVE SMA1 Mode D'emploi page 6


Heat does not spread horizontally, thus at a distance of just a few centimeters from
the cooking zone, the glass remains relatively cool" to the touch.

This appliance is equipped with a "residual heat" indicator that lights up if the
temperature of the hob is above 70°C, even when turned off. Residual heat persists
for a relatively long time after the cooking zone has been switched off.

Absolutely do not touch the cooking areas or leave flammable objects near it until
the lamp is off.

The indicator lamp turn off automatically once the temperature of the cooking
zone falls below 70°C.
Electrical Connection

Before connecting the appliance to the electricity supply, check that the voltage
corresponds to that on the data plate and that the power supply cable is suitable
for the appliance load also stated on the data place.

If the appliance is connected directly to the mains, fit an all-pole disconnect switch
with minimum contact gap of 3 mm, adequate for the appliance load and
complying to regulations.

The plug used must support the power of work of the appliance.
- Do not use reducers, adapters or switches for connection to the mains, since these could
overheat and cause burns
- Earth connection is required by law
If the power cable must be replaced, use a cable having identical characteristics to the
original supplied by the manufacturer, suitable for the load and temperature. This is
available from After-sales service.
Important!
- These instructions are intended for qualified technicians.
- The appliance must be installed correctly, in compliance with current laws.
- Before carrying out any operation on the appliance, it must be disconnected from the
electric supply.
The appliance must be installed and operated in suitable areas, and in compliance with
current laws.
WARNINGS
EN/3