Publicité
Les langues disponibles
Les langues disponibles
Appliance without power cable:
necessary, fit the copper bridge supplied. Mains power cable: Type H05 VV-F or a higher
grade, min. wire cross-section 1.5 mm2.
Appliance with prefitted power cable:
trained after-sales engineer.
Installing:
Do not trap the power cable and do not route it over sharp edges. If the oven
is a built-under type, route the cable on the rear corners of the oven to the socket.
Tiled work surfaces:
Removing the hob:
Disconnect the appliance from the power supply. Push out the hob
from below.
Insert the hob in the existing worktop cut-out with a depth of 500 mm
1. Mark the centre of the cut-out
2. Put the hob in place
3. Align the markings on the hob surround and cut-out
4. Press in the hob
5. Screw the bracket provided
Electrical Connection
Warning : For the hob's installation, use protective gloves. The visible surfaces may have
sharp edges .
Connect the device to the mains and check the operation .
voltage , see the rating plate .
Connect adhering strictly to the relevant diagram.
1. Brown
2. Blue
3. Yellow and green
Wiring Diagram
INSTALLATION
Only connect as per the connection diagram. If
The power cable must only be replaced by a
Seal the tile joints with silicone rubber.
EN/2
Publicité
