Domo DO2520 Mode D'emploi page 35

PARTS
1. Safety interlock system
2. Observation window
3. Turntable shaft
4. Turntable ring assembly
5. Glass turntable
6. Control panel
7. Protection cover wave guide -
never remove this cover!
BEFORE THE FIRST USE
TURNTABLE INSTALLATION
· First place the turntable ring in the middle of the microwave oven.
· Place the turntable on the ring. Make sure that the middle of the
turntable fits into the turntable shaft.
CAUTION:
· Never place the glass tray upside down. The glass tray should never
be restricted.
· Both glass tray and turntable ring assembly must always be used during cooking.
· All food and containers should be placed onto the glass turntable during cooking at all times.
· If the glass tray or turntable ring assembly cracks or breaks, contact your nearest authorized service
center. Or you can order the accessories in our webshop: webshop.domo-elektro.be
INSTALLATION
· Remove all packaging material and accessories.
· Check the oven for any damage, such as dents or a damaged door. Do not use the oven if it is
damaged. Remove the protective film around the machine, this is applied to avoid scratches.
· Choose a place to install the
microwave, where there is sufficient
open space for the air intake and
exhaust.
The microwave oven must stand at
least 85 cm high.
Make sure that the left, right and back
side are at least 20 cm from the wall or
cupboard. One side of the microwave
oven must be completely exposed. The
open space above the microwave must
be at least 30 cm.
www.domo-elektro.be
35
DO2520