Motorola BEARCOM BC300D Mode D'emploi page 20

MN006027A01-AC
Chapter 6 : Calls
3 Wait for the Talk Permit Tone to end, and speak into the microphone.
4 To listen, release the PTT button.
If your radio does not detect voice activity for a predetermined period, the call ends.
6.2.2
Responding to Private Calls
When and where to use: When you receive Private Calls, your radio shows the following indications:
• The green LED illuminates.
• Your radio unmutes and the incoming call sounds through the speaker.
Procedure:
1 To respond, press the PTT button.
2 Wait for the Talk Permit Tone to end, and speak into the microphone.
3 To listen, release the PTT button.
If your radio does not detect voice activity for a predetermined period, the call ends.
6.3
All Calls
All Calls are one-way calls from an individual radio to all radios on a channel. All Calls are used for
making important announcements. The recipients on the channel cannot respond to All Calls.
When you receive All Calls, your radio shows the following indications:
• A tone sounds.
• The green LED illuminates.
• Your radio unmutes and the incoming call sounds through the speaker.
All Calls do not wait for a predetermined period before ending. You can only continue with programmed
button functions after the All Call ends. If you switch to a different channel during an All Call, your radio
stops receiving the call.
6.3.1
Making All Calls
Procedure:
1 To select a channel with an active group ID, toggle the Channel Selector knob.
2 To call, press the PTT button.
3 Wait for the Talk Permit Tone to end, and speak into the microphone.
20