Publicité
FUNCTION
OF EACH
PART-
A. REVERSE
STITCH
BUTTON
The machine will sew in reverse (at low speed)
while the button is pressed,
When released, machine will sew forward.
B.NEEDLE
UP/DOWN
BUTTON
Needle stop position will be changed up or down
by pressing this button,
The indicator lamp will turn on when the needle is
down position,
C.TWIN
NEEDLE
BUTTON
By pressing this button, the stitch width will reduce
automatically for sewing with twin needle. (See
page 70)
The indicator lamp will turn on,
D.PRESSER
FOOT
LIFTER
The presser foot is lifed up or down by this lever.
NOTE:
Machine will not start when the presser foot is
lifted. (Except for bobbin winding)
E. DROP
FEED LEVER
The fabric feed dogs project up through the needle
plate, directly below the presser foot. Their
function is to move the fabric being sewn. The
drop feed lever controls the fabric feed dogs.
For ordinary sewing, move the lever to the right.
This raises feed dogs to their highest position. For
most sewing, the lever should be in this position.
For darning or free motion embroidery
or
whenever fabric is to be moved by hand, move the
lever to the left to lower the fabric feed dogs.
F. PRESSURE
REGULATOR
The pressure on the presser foot is determined
by
the weight of fabric.
To increase the pressure, turn dial at 3.
To decrease the pressure, turn dial at 1.
For ordinary sewing, turn dial at 2.
G.HAND
WHEEL
By turning the hand wheel, the needle will raise or
lower. You should turn the wheel toward you.
H,TOP
COVER
To open the top cover, lift up the left side of cover.
20
Publicité
