Table des Matières
Publicité
ENGLISH
2.3) Cutting
Continue operating the moveable handle, the lower blade advances gradually until the
cable is fully cut.
▲
T
HE TOOL IS DESIGNED FOR CUTTING COPPER
!
DO NOT ATTEMPT TO CUT STEEL OR
2.4) Blade opening
Press the pressure release lever (58) for the rapid retraction of the ram and subsequent
blade (18) opening.
2.5) Rest setting
After completion of the work, press the release lever (58) to release the oil pressure (refer
§ 2.4).
3. WARNING
The tool is robust and requires very little daily maintenance.
Compliance with the following points, should help to maintain the optimum performance
of the tool:
3.1) Accurate cleaning
Dust, sand and dirt are a danger for any hydraulic device.
Every day, after use, the tool must be cleaned with a clean cloth, taking care to remove
any residual, especially close to pin and moveable parts.
3.2) Storage
When not in use, the tool should be
stored and transported in the canvas
bag, to prevent damage.
Canvas bag: ref. 010; size 545x160
mm (21.4x6.3 in.); weight 0,15 kg
(0.33 lbs).
3.3) Head rotation
For ease of operation, the tool head can rotate through 90°.
Warning: do not attempt to turn the head if the hydraulic circuit is pressurised.
,
ALUMINIUM AND TELEPHONE CABLES
ACSR
.
CONDUCTORS
CANVAS BAG
:
44
FIG. 2 TOOL POSITION FOR MAINTENANCE OPERATIONS
POSITION DE L'OUTIL POUR L'ENTRETIEN
WERKZEUG WARTUNGSPOSITION
COLOCACION PARA LAS OPERACIONES DE MANTENIMIENTO
POSIZIONAMENTO PER LE OPERAZIONI DI MANUTENZIONE
3
28
03
58
12
14
13
18
01
02
Publicité
Table des Matières
