Makita TD001G Manuel D'instruction page 14

Application mode
Wood mode
T mode (1)
T mode (2)
Bolt mode (1)
Bolt mode (2)
Bolt mode (3)
: The lamp is on.
: The lamp is blinking.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing driver bit/
socket bit
12 mm
(15/32")
Use only the driver bit/socket bit shown in the figure. Do
not use any other driver bit/socket bit.
While registering the application mode
► 1. Driver bit 2. Sleeve
To install the driver bit, insert it into the sleeve as far as it will go.
9 mm
(3/8")
► 1. Driver bit 2. Sleeve
To remove the driver bit, pull the sleeve in the direction
of the arrow and pull the driver bit out.
14 ENGLISH
When the registered application mode
turns on
1 2
1 2