Publicité
Les langues disponibles
Les langues disponibles
PART NUMBER: E771SSL000
STEP 21: Carefully and gently remove the two tape liner sections shown below. Pulling with too much force or too quickly can tear the tape liner. TIP: If the liner tears,
pull the same liner from the opposite direction. Then remove corner alignment templates.
STEP 22: Use a towel and apply firm pressure (approximately 15lbs of force) to the areas highlighted in yellow.
STEP 23: Inspect part for any areas not adhering to the bumper. Firmly pressed down as needed. Done.
ISSUE
SUBARU OF AMERICA
08/15/2023
PAGE 9 / 9
PART NUMBER: E771SSL000
01
Publicité
