Publicité
Les langues disponibles
Les langues disponibles
NOTES
ON
INSTALLATION
e@Place the turntable
on a level surface.
@ Avoid any vibration such as from speakers, slamming of doors,
etc.
cover can
be opened.
a
XS
rn
E
E
j=)
ite]
t+
475 mm
(1834in.)
e@The turntable
has
resilient
feet that
isolate
the
mechanism
from external
shock and vibration.
Use them
in locked
position,
but when
placing the turntable on an uneven surface, turn each
foot until the unit is level.
Resilient Foot
To remove
the dust cover
Open the dust cover fully and slide it as illustrated while holding
it with
both
hands.
OPERATING
VOLTAGE
Before connecting the unit to the power source, check that the
voltage selector setting is correct for your power
supply.
If the
selector must
be reset, disconnect
the ac
power
cord
and
set
the
selector
to the proper voltage
using a screw
driver.
voltage selector is located at the rear panel.)
(The
oom
The figure shows the voltage disposition
other than that of the UK model.
Notice
for the customers
in the
United
Kingdom
;
IMPORTANT
é
The wires in this mains lead are coloured in accordance
with
the
following code:
Blue:
Neutral
Brown:
Live
As the colours of the wires in the mains lead of this apparatus
may not correspond with the coloured marking
identifying
the
terminals in your plug, proceed as follows:
The wire which is coloured blue must be connected to the terminal
which is marked
with the letter N or coloured
black.
The wire
which is coloured brown must be connected to the terminal which
is marked with the letter L or coloured red.
Publicité
