Publicité
Les langues disponibles
Les langues disponibles
- Any parts should be installed properly to comply with the conditions of the machine safe
operation.
- A protective guard or other part that is damaged should be properly repaired or replaced by an
authorized service centre unless otherwise indicated in this instruction manual.
11. Warning
The use of any accessory or attachment, other than one recommended in this instruction manual
may present a risk of injury (to persons or animals) and may cause damages.
The user and/or operator are responsible for any damages or injury caused to properties and/or
persons.
12. Have your tool repaired by a qualified person
Repairs should only be carried out by qualified persons using original spare parts; otherwise this
may result in considerable danger to the user.
The use of unauthorized parts or failure to follow the maintenance instructions may result in injury
or damage.
13. Remarks
The safety precautions and instructions given in this manual are unable to cover in detail all the
conditions and situations that may arise.
The operator and/or user must use common sense and caution when operating the product
especially for any matters that are not referred in the above.
14. The protective device (if any) must be placed in the appropriate position, to avoid danger for
the user.
3.2- Safety warnings regarding the use
Important notice! Observe any national safety regulations regarding installation, operation and
maintenance.
1. Become familiar with the controls and the proper use of the equipment.
2. The use of this product by children is forbidden.
3. Only well-instructed adults should operate the product. This product is not intended for use by
persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use
of the product by a person responsible for their safety.
4. Use only accessories with a permissible speed at least as high as the no-load speed of the tool.
5. Do not use tool if damaged, eccentric or vibrating.
6. Do not use tool if the blade is damaged, cracked, eccentric or vibrating.
7. Never grab or touch the blade or cylinder during operation.
8. Work may cause flying debris. Wear proper protective equipment (e.g. goggles...)
9. Residual risks
Even when the tool is used as prescribed; it is not possible to eliminate all residual risk factors.
The following hazards may arise in connection with the tool's construction and design.
a. Risk of injury if you touch the blade while in use.
b. Risk of body injury or property damage from flying debris.
10. Before you begin:
- The machine must be properly assembled before use.
- The machine should be carefully checked before each use. You should only work with a machine
that is in good condition. If you notice a fault on the machine that may cause danger to the operator
or the environment, do not operate the unit until the default has been repaired.
10.1. Browse the mowing area to:
- remove all objects and foreign materials that may be thrown by the moving blade,
- identify hard objects or risk areas to avoid damaging the lawnmower
10.2. Check the blades', the safety features and cutting device conditions. Replace or repair any
defective part.
10.3. Remove all people or animals of the area.
All manuals and user guides at all-guides.com
Page 15 / 28
Publicité
