Delta UNISAW 36-R31 Manuel D'utilisation page 13

P
14. Hold the blade guard and lower the saw blade. Install
the table insert (E) Fig. 25 in the open ing of the saw
table.
15. Place a straight edge (B) across the table at both ends
of the table insert (Fig. 26).
Ensure that the table insert (A) is level with the
table.
To adjust, turn the adjusting screws (C) with the 1/8" hex
wrench.
MOTOR COVER
NOTE: If your Unisaw uses an LVC Starter Box, attach the
two bottom spring clips to the motor cover.
1. Align the hole in the motor cover clip with the hole in
the motor cover. Place a 13/64" flat washer on a 10-32
x 1/2" screw (A) Fig. 27. Insert the screw through the
hole in the motor cover clip and thread the screw (A) in
the tapped hole in the motor cover. Repeat this process
for the remaining motor cover clip.
2. Place the motor cover in the opening of the Unisaw
(Fig. 28). Place the rear motor cover clips inside the
motor opening. Push the front of the motor cover until
all four motor cover clips are engaged.
3. Align the hole (B) Fig. 29 in the bottom of the motor
cover with the hole in the side of the saw cabinet. Place
a 1/4" flat washer on a 1/4-20 x 5/8" hex-head screw.
Insert the screw through the hole in the motor cover.
Thread the screw in the hole in the side of the motor
cabinet. Tighten securely.
NOTE: To detach the motor cover, remove the 1/4-20 x 5/8"
hex-head screw (B) Fig. 29, and push the motor cover to
one side. This will depress the clips and you can remove
the cover.
Fig. 28
C
D
Fig. 24
13
E
C
A
Fig. 26
A
Fig. 25
B
C
Fig. 27
B
Fig. 29