Publicité
When your stove acts out of the ordinary, the first reaction is to call for help. This guide may save time and money by
enabling you to solve simple problems yourself. Problems encountered are often the result of only five factors: 1) poor
fuel; 2) poor operation or maintenance; 3) poor installation; 4) component failure; 5) factory defect. You can usually
solve those problems related to 1 and 2. Customer service can solve problems relating to 3, 4 and 5. Refer to diagrams
on page 25 to help locate indicated parts. For the sake of troubleshooting and using this guide to assist you, you should
look at your heat level setting to see which light is flashing.
• Disconnect the power cord before performing any maintenance! NOTE: Turning the ON/OFF Switch to "OFF" does
not disconnect all power to the electrical components of the stove.
• Never try to repair or replace any part of the stove unless instructions for doing so are given in this manual. All other
work should be done by a trained technician.
Display is Flashing "E1"
Possible Causes
The stove is consuming too much fuel
The convection blower is overheating and
tripping the internal temperature shutoff.
The stove is being left on the highest setting for
extended periods of time.
Fuel other than wood pellets is being burned in
the stove.
Power surge or brown out situation.
High Limit Switch is malfunctioning.
ATTENTION: THIS WOOD HEATER NEEDS PERIODIC INSPECTION AND REPAIR FOR PROPER OPERATION.
IT IS AGAINST FEDERAL REGULATIONS TO OPERATE THIS WOOD HEATER IN A MANNER INCONSISTENT
© 2021 United States Stove Company
Possible Remedies: (Unplug stove first when possible)
Adjust the fuel adjuster slide (see the "How To Adjust The Fuel
Adjuster" section of this manual). Close the slide about 1/4" after
your stove cools down. Restart your stove. If your display shows
E1 again, close the slide another 1/4" and restart.
Clean any dust off of the windings and fan blade. If oiling the
blower does not help, the blower may be bad.
If operating the heater on the highest heat setting, the room
temperature could increase enough and lead to potential
overheating situations. If this happens try operating at a lower
heat setting.
This pellet stove is designed and tested to use wood pellets.
Check for signs of fuel other than wood pellets. No other types
of fuel have been approved for this pellet stove. If there are signs
of other types of fuel being used, stop using them immediately.
A power surge, spike, or voltage drop could cause the high limit
switch to trip. Check to see if a surge protector is being used on
the stove. If not, recommend one to the customer.
If the other items check out OK, replace the high limit switch.
WITH OPERATING INSTRUCTIONS IN THIS MANUAL.
TROUBLESHOOTING GUIDE
18
Publicité
