Gaggenau RF461705 Notice D'utilisation page 17

Display lock for cleaning
You can use this function to switch off the touch function
of the controls for 10 seconds. During this time you can
clean the display.
~ "Cleaning the display" on page 26
Press à button to open the main menu.
1.
2. Press I button.
The cleaning display appears, and the countdown starts.
Switching ice cube production on or off
9
CAUTION
Damage to the appliance!
Never store bottles or food in the ice cube
container, even for short periods. This can block
and damage the ice maker.
Ice cube production starts as soon as the appliance has
reached the set temperature.
Note: Ice cube production stops automatically when the
ice cube container is full.
Switching ice maker on or off
Press à button to open the main menu.
1.
2. Press C button to move to the menu item Ice cube
production.
Press I/& button.
3.
Eco mode
Eco mode switches the appliance to energy-saving
operation.
The appliance automatically sets the following
temperatures:
Freezer compartment: +3 °F (-16 °C)
▯
Switching Eco mode on or off
Press à button to open the main menu.
1.
2. Press C button to move to the menu item Eco mode.
3. Press I/& button.
The temperature is changed, and the display shows the
new temperature. When Eco mode is switched off, the
recommended temperature is set.
Note: You can also switch Eco mode on or off by
adjusting the temperature with A/@ buttons.
Reset water filter counter
After replacing the water filter, you have to reset the
water filter counter.
1. Press à button to open the main menu.
2. Use C button to move to the menu item Reset water
filter counter.
Use ™ button to confirm and confirm the query again
3.
with ™ button.
Note: The water filter counter will not be reset if you
abort the query or take longer than 10 seconds to make
an input.
Self-test
This function can be used to start fault analysis on your
appliance.
~ "Appliance self-test" on page 30
Setting the brightness of the control
panel
1. Press à button to open the main menu.
2. Press B button to move to the menu item Basic
settings.
Press ™ button.
3.
4. Press % button to open the menu item Brightness.
Press B C buttons to set the required brightness.
5.
6. Press ™ button.
The setting is saved.
Press ' button to exit the menu.
7.
Operating the appliance
en-us
17