Samsung DV36J4000E Serie Manuel D'utilisation page 23

Digital Graphic
2
Display
Wrinkle Prevent
3
Selection Button
Dry Level
4
Selection Button
Temp Selection
5
Button
Time Selection
6
Button
Adjust Time
7
Start/Pause
8
selection button
Power button
9
DV36J4000E(G)-03064D-00_EN_150414.indd Sec5:23 DV36J4000E(G)-03064D-00_EN_150414.indd Sec5:23
The display window shows the estimated time remaining in the cycle after you have
pressed the Start/Pause button. The estimated time remaining may fluctuate as the
cycle progresses.
The Drying light will illuminate and remain lit until the cycle is complete. When your dryer is
in the cool-down phase, the Cooling light will illuminate. When your dryer is in the wrinkle
prevent phase, the Wrinkle Prevent light will illuminate.
When the cycle is complete, "END" appears in the display panel until you open the dryer
door, press the Power, Close, or Start button, or 5 minutes have passed.
If your dryer is paused during a cycle, the indicator lights will blink until the Start/Pause
button is pressed.
Wrinkle Prevent provides approximately 180 minutes of intermittent tumbling in
unheated air at the end of the cycle to reduce wrinkling. Press the Wrinkle Prevent
button to activate this feature.
The indicator light above the button will illuminate when you select Wrinkle Prevent.
The load is dry and you can remove it at any time during the Wrinkle Prevent cycle.
To select the dry level in the Normal, Heavy Duty, or other Sensor Dry cycles, press
the Dry Level button repeatedly to scroll through the dry level settings. An indicator
light illuminates next to each dryness level as you scroll through. Stop at your desired
dryness level. Larger or bulkier loads may require the Very Dry or More Dry setting for
complete dryness. Damp Dry is designed to partially dry items. Use for items that lay flat
or hang to dry.
To select the correct temperature for a load, press the Temp button repeatedly to scroll
through the temperature settings. An indicator light illuminates next each temperature
setting as you scroll through. Stop at your desired temperature setting.
High – For sturdy cottons or those labeled Tumble Dry.
Medium – For permanent press, synthetics, lightweight cottons, or items labeled
Tumble Dry Medium.
Low – For heat sensitive items labeled Tumble Dry Low or Tumble Dry Warm.
Extra Low – Provides the lowest heated dry temperature possible.
When using Manual Dry cycles, you can adjust the time by pressing the Time Selection
button.
During the Sensory Dry cycle, the time light indicator is off because exact drying times
are determined by fluctuating humidity levels.
You can add time to the automatically set times in the Manual Dry cycles (Time Dry,
Quick Dry, Wrinkle Release or Air Fluff).
If you press and hold the Adjust Time button, the time slowly increases until it reaches
the maximum time setting. When you set the time to the maximum, and you briefly
press the button, the time returns to the lowest time setting.
After selecting a preset time using the Time button, you can adjust the time using
the Adjust Time button.
For example, press the Time button to select 40 minutes, and then press the
Adjust Time button to add 5 minutes.
Press to pause and restart programs.
Press once to turn your dryer on. Press again to turn it off. If you turn your dryer on and
do not touch any buttons for 10 minutes, the power automatically turns off.
English - 23
2015-04-14 2015-04-14 3:52:04 3:52:04