Philips Saeco PICOBARISTO HD8925 Mode D'emploi page 29

English
28
Problem
The AquaClean filter icon
does not appear on the
display after I replaced
the filter.
The AquaClean filter is
installed, but the
descaling message
appears.
The AquaClean filter does
not fit.
There is water under the
machine.
Cause
You did not confirm activation
in the machine menu.
You have not activated the
AquaClean filter in the machine
menu.
You need to remove air from
the filter.
There is still water in the water
tank.
You are trying to install another
filter than the AquaClean filter.
The rubber o-ring is not
attached to the AquaClean
filter.
The drip tray is too full and has
overflowed.
The machine is not placed on a
horizontal surface.
Solution
Confirm the activation of the filter in the
machine menu. If the display shows
'START CALC CLEAN', you first need to
descale the machine. Remove the
AquaClean filter before descaling and
reinsert it afterwards.
First descale the machine and then
install a new AquaClean filter. This will
reset the filter counter to 0/8. Always
confirm filter activation in the machine
menu, also after filter replacement.
Let air bubbles come out of the filter.
Empty the water tank before you install
the filter.
Only the AquaClean filter fits into the
machine.
Check the packaging for the o-ring and
attach it to the AquaClean filter.
Empty the drip tray when the 'drip tray
full' indicator pops up through the drip
tray. Always empty the drip tray before
you start descaling the machine.
Place the machine on a horizontal
surface so that the 'drip tray full'
indicator works properly.