Publicité
Les langues disponibles
Les langues disponibles
ATTACHING THE FAN BLADES
CAUTION: Remove the rubber shipping blocks attached to the face
of the motor. These blocks keep the motor from shifting during
shipping and MUST be removed during installation.
Step 1. Attach the blade to the blade bracket using the screws and
washers as shown in Figure 14. Start screw into bracket. Repeat for
the two remaining screws.
Step 2. Make sure the blade is straight and tighten each screw.
Step 3. Fasten blade assembly to motor using blade arm screws.
(Fig. 14)
INSTALLING THE SWITCH HOUSING
NOTE: Before continuing installation, confirm that the power is still
turned off at the main circuit breaker or by removing the correct fuse.
Turning the power off using a wall switch is not sufficient to prevent
electrical shock.
Step 1. While holding the switch housing under your ceiling fan, make
the wire connections. Plug the connector of the green ground wire from
the fan to the connector of the bare wire from the switch housing. Then
connect the small wire connector from the fan (AA) to the small wire
connector from the switch housing (aa) and connect the larger wire
connector from the fan (BB) to the larger wire connector from the switch
housing (bb). (Fig. 15)
Step 2. Carefully push all the wires into the switch housing. Attach the
switch housing to the mounting ring with the screws provided. Make sure
each screw is tight. (Fig. 15)
14
| KICHLER.COM
Blade arm
Screw
Blade arm
Green
AA
Mounting ring
BB
aa
bb
Bare
Screws
Switch housing
Fob
Screw
Washer
Blade
Fig. 14
Fig. 15
Publicité
