Kichler RENEW ENERGY STAR Manuel D'instructions page 10

HANGING THE MOTOR ASSEMBLY
Close-to-Ceiling Installation
Step 1. Pass the 120-volt supply wires through the center hole in the
ceiling hanger bracket as shown in Fig. 5.
Step 2. Secure the hanger bracket to the ceiling outlet box with the
screws and washers provided with your outlet box.
Step 3. Remove three of the six screws and lock washers (every other
one) from the collar of top motor. (Fig. 8)
Step 4. Place the ceiling canopy with decotation ring and the gasket
over the collar at the top of the motor. Align the mounting holes with
the holes in the motor and fasten using the screws and lock washers
provided. (Fig. 8)
Step 5. Tighten the mounting screws securely.
WARNING: Failure to completely tighten the three screws in step 4
could result in fan loosening and possibly falling.
Step 6. Hang the fan on the hook of the hanger bracket. Be certain that
the canopy is fully locked into hook as shown in Fig. 9. This will allow you
to make the electrical connections.
10
| KICHLER.COM
Screws and Lock
washers(3 of 6 places)
Canopy
Gasket
Collar
Ceiling mounting
Hook
Fig. 8
bracket
Canopy
Fig. 9