Mitsubishi Electric Mr.SLIM PKA-AHA4 Serie Manuel D'utilisation page 8

9. Operation Manual for IR wireless remote controller
9.1 Parts Names
Remote controller display
* For explanation purposes, all of the items
that appear in the display are shown.
* All items are displayed when the Reset
button is pressed.
Set Temperature buttons
Fan Speed button (Changes fan speed)
Airflow button (Changes up/down airflow direction)
Mode button (Changes operation mode)
Note:
When using the IR wireless remote controller, point it towards the receiver on the indoor unit.
If the IR wireless remote controller is operated within approximately 2 minutes after power is
supplied to the indoor unit, the indoor unit may beep twice as the unit is performing the initial
automatic check.
The indoor unit beeps to confirm that the signal transmitted from the IR wireless remote con-
troller has been received. Signals can be received up to approximately 7 meters in a direct
line from the indoor unit in an area 45° to the left and right of the unit. However, illumination
such as fluorescent lights and strong light can affect the ability of the indoor unit to receive
signals.
If the operation lamp near the receiver on the indoor unit is blinking, the unit needs to be in-
spected. Consult your dealer for service.
Handle the IR wireless remote controller carefully! Do not drop the IR wireless remote con-
troller or subject it to strong shocks. In addition, do not get the IR wireless remote controller
wet or leave it in a location with high humidity.
To avoid misplacing the IR wireless remote controller, install the holder included with the IR
wireless remote controller on a wall and be sure to always place the IR wireless remote con-
troller in the holder after use.
8
COOL
DRY
AUTO
FAN
HEAT
ON/OFF button
Check button
Test Run button
Transmission area
Transmission indicator
TEST
CHECK
RUN °F
MODEL
°C
Timer indicator
SELECT
STOP AMPM
FAN
SWING
START AMPM
NOT AVAILABLE
Operation areas
Timer Off button
Timer On button
Hour button
Minute button
Set Time button (Sets the time)
Louver button (Changes left/right airflow direction)
Reset button
1. Remove the top cover, insert 2 AAA batteries,
2. Press the Reset button.
Battery installation/replacement
and then install the top cover.
1
2
3
Top cover
2 AAA batteries
Insert the negative (–)
end of each battery
first. Install the bat-
teries in the correct
directions (+, –)!
Press the Reset but-
ton with an object that
has a narrow end.