Volpi PV360 Mode D'emploi page 34

12. Assembly
Check that the pruning shears and batteries are clean and dry, and then place the battery in the
battery compartment on the pruner.
13. Operations start procedure
Please wear suitable cloth and glove when operate this tool. Always check tools before
use, make sure on/off switch and safe switch are all ok. The power should be put off
when you loosen the trigger. Stop using the tool in case of switch failure. Always check
rated voltage of battery match pruning shear.
Switch off the machine, blade will stop in many second, must sure blade stop fully before
touch it, otherwise blade will hurt your body.
•
Press the power switch. After warning tone, please pull the trigger two times without holding. Do
not overload cutting, it will protect pruning shear and battery not be damaged. Do not cutting
over the dimension specified in the technical information table.
•
User just loose trigger when the blade has been jammed by branch, the blade will resume
maximum position.
Caution: Do not sway the pruner from the left to right in order not to damage the edge of
blade during the resume process of blade.
Check the working frequency of the blade in order to verify the good working condition.
34